Chrysler 200 I (2011-2014) fuse box diagrams & schemes (2024)

Years of production: 2011 2012 2013 2014

Table of contents

Integrated Power Module fuses
Information about the model

Related diagrams & schemes

Chrysler 200 II (2015-2017) Fuse box

Integrated Power Module fuses

Integrated Power Module

The Integrated Power Module is located in the enginecompartment near the air cleaner assembly. This centercontains cartridge fuses and mini fuses. A label thatidentifies each component may be printed on the insideof the cover. Refer to the graphic below for FUSES/TIPMlocation.

When installing the Integrated Power Modulecover, it is important to ensure the cover is properlypositioned and fully latched. Failure to do somay allow water to get into the Integrated PowerModule, and possibly result in an electrical systemfailure.

When replacing a blown fuse, it is important touse only a fuse having the correct amperage rating.The use of a fuse with a rating other than indicatedmay result in a dangerous electrical system overload.If a properly rated fuse continues to blow, itindicates a problem in the circuit that must becorrected.

Cavity	Cartridge Fuse	Mini Fuse	Description
1	40 Amp Green	-	Power Top Module– If Equipped
2	-	20 Amp Yellow	Brake Vacuum Pump
3	-	10 Amp Red	Center High Mounted Stop Light (CHMSL)/Brake Switch
4	-	10 Amp Red	Ignition Switch
5	-	20 Amp Yellow	Trailer Tow – If Equipped
6	-	10 Amp Red	Power Mirror Switch/Climate Controls
7	-	30 Amp Green	Ignition OffDraw (IOD) Sense 1
8	-	30 Amp Green	Ignition Off Draw (IOD) Sense 2
9	40 Amp Green	-	Battery Feed – Power Seats – If Equipped
10	-	20 Amp Yellow	Instrument Panel/ Power Locks/Interior Lights
11	-	15 Amp Lt Blue	Selectable Power Outlet (Inside Center Arm Rest)
12	-	—	—
13	-	20 Amp Yellow	Ignition/Cigar Lighter
14	-	10 Amp Red	Instrument Panel
15	40 Amp Green	-	Radiator Fan Relay
16	-	15 Amp Lt. Blue	Sunroof – If Equipped
17	-	10 Amp Red	Wireless Control Module (WCM)/ Clock/Steering Control Module (SCM)
18	40 Amp Green	-	Auto Shutdown (ASD) Relay
19	-	20 Amp Yellow	Audio Amplifier – If Equipped
20	-	15 Amp Lt. Blue	Radio
21	-	10 Amp Red	Siren – If Equipped
22	-	10 Amp Red	Ignition Run – Climate Controls/Hot Cupholder – If Equipped
23	-	15 Amp Lt. Blue	Auto Shutdown (ASD) Relay 3
24	-	25 Amp Natural	Sunroof – If Equipped
25	-	10 Amp Red	Ignition Run - Heated Mirrors - If Equipped
26	-	15 Amp Lt. Blue	Auto Shutdown (ASD) Relay 2
27	-	10 Amp Red	Ignition Run - Occupant Classification Module (OCM)/ Occupant Restraint Controller (ORC)
28	-	10 Amp Red	Ignition Run - Occupant Classification Module (OCM)/ Occupant Restraint Controller (ORC)
29	-	— Hot Car (No Fuse Required)
30	-	20 Amp Yellow	Ignition Run – Heated Seats – If Equipped
31	-	— Spare
32	30 Amp Pink	-	AutoShutdown (ASD) Relay 1
33	-	10 Amp Red	Switch Bank/ DiagnosticLink Connector/ Powertrain Control Module (PCM)
34	30 Amp Pink	-	Anti-Lock Brakes (ABS) Module – If Equipped/Electronic Stability Control (ESC) Module – If Equipped
35	40 Amp Green	-	Anti-Lock Brakes (ABS) Module – If Equipped/Electronic Stability Control (ESC) Module – If Equipped
36	30 Amp Pink	-	Passenger Door Module (PDM)/Driver Door Module (DDM)
37	-	25 Amp Natural	Power Top Module – If Equipped

Information about the model

There was a time when people preferred a mid-size sedan for their families. It providesoptimal performance as well as luxury to the people. Chrysler launched its mid-size sedanthat is convertible with some redesign. In the year 2011, it launched a sedan equipped withpower, an upscale interior, better handling, and maximum comfort.This four-door family sedan or two-door convertible is equipped with bulk loads offeatures. It specifically addresses the need for those who want all the equipment andoptimal performance levels. The specified price of Chrysler 200 makes it a hit in itssegment. If one is looking for some innovative features and adequate equipment, then thisis a great alternative.

Chrysler 200: First Generation

Chrysler 200 contains all the features related to safety, entertainment, and performance. Atthat time, this car was equipped with top-notch features such as USB connectivity, LEDcabin lighting, motorized heated leather seats, a touchscreen navigation system, hard-driveaudio storage, and some other ones.

From a technical point of view, 200 was offered with different variants that offerednumerous ranges. One can opt for a two-door convertible or four-door sedan. It also has aunique grade of interiors, which provides a luxurious feel to the customers. The engine of200 is a 2.4 liter four-cylinder unit with 173 horsepower that provides optimalperformance. It comes with a four-speed automatic transmission and also with 6-speedautomatic transmission.

This was a value for money vehicles due to its overall looks. Apart from that, it was capableof providing a comfortable ride. With the smooth performance of the engine, the Chrysler200 achieves the top-notch position in the segment. In addition to that, the fuel efficiency isalso a plus point of this car. Those who are concerned about the boot space can getmaximum cargo volume after the seats get folded.

All Chrysler 200 I info & diagrams provided on this site are provided for general information purpose only. Actual Chrysler 200 I (2011-2014) diagrams & schemes (fuse box diagrams & layouts, location diagrams, wiring diagrams etc.) may vary depend on the model version.

Comments (14):

~Jerry 03-02-2019
Have chrysler 200 2013 checked fuses my menu doesn't come on where its shows tires pressure miles to go on gas system check not even my gas gauge moves

~Keith 07-06-2019
What color is the fuse for Chrysler 200 for the horn

~ralphcaddy 29-08-2020
my back brake light thats in my rear window is not working can you tell me which fuse operate it

~Thomas meyer 16-09-2020
What would cause a Chrysler 200 to shut down while driving down the roadI talked to a guy who saidHe had the same problems and he said it was an ignition fuse. Is this true give me your feed back

[emailprotected] 24-03-2021
Is there a fuse for the window washer pump?

~Tyree jackson 14-04-2021
Which fuse is for the horn? My horn is going off randomly

[emailprotected] 01-10-2021
The horn sounds automatically at anytime. Is there a fuse to repair the problem

~Steve Register 22-10-2021
Car starts runs about ,1 minute then shuts down.

~Steve Register 22-10-2021
Car starts runs about ,1 minute then shuts down. No power to fuses 23,25,26 and relay 32

~Scott 09-12-2021
After doing a volt meter test to find the parasitic draw on my Chrysler 200 fuse number 14 is the culprit !witch is the instrument panel ! Does that mean the entire panel must be replaced or can there be a route cause please help

~Bob 08-01-2022
What colour fuse is windshield washer

~Sybrand 11-08-2022
My 2012 Chrysler 200, on the instrument pannel reads "Left front turn signal not working" when it's turned on and the same for the right side. I cant find a fuse for it. Any idee what can be the cause? Thanks

~Gustavo 17-08-2022
Try to start but dost want to new battery an starter

~Sharon 13-03-2023
What fuse is for my 2011 Chrysler 200. It has been blowing low but now no sound. Thanks for your help!

Add comment

Chrysler 200 I (2011-2014) fuse box diagrams & schemes (2024)

FAQs

Where can I find fuse diagram for my car? ›

To locate the fuse specification chart for your vehicle or to learn how to change a fuse, refer to the "Fuses" section of your Owner's Manual.

Show Me More ›

How do I know which fuse is blown in my fuse box? ›

Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

What are the main fuses in fuse box? ›

Your fuse box will have two sets of fuses. At the bottom will be 15-amp and 20-amp screw-in fuses with glass faces that are exposed and visible. These fuses will service branch light circuits and outlet circuits. At the top will be 30-amp or 40-amp cartridge main fuses for ovens, laundry rooms, or stoves.

Get More Info ›

How to tell if a relay is bad? ›

Listen for an audible click as the electromagnetic coil activates and the internal switch closes. Switch your multimeter to continuity mode, listen for the audible beep, and test for continuity between the switch pins. If there's no beep, it means the switch pins are stuck open and your relay is faulty.

Keep Reading ›

Which of the following is the most common problem associated with fuses? ›

The most common cause of a blown fuse or a tripped circuit breaker is a circuit overload. This occurs when you're attempting to draw more electricity than the circuit can handle, such as when you have too many things plugged into a circuit.

Learn More Now ›

Can a fuse be bad but not blown? ›

Sometimes a fuse is bad but not necessarily blown. In this case, the best way to test it is with a test light or a multimeter. These are both relatively inexpensive tools and provide an easy way of checking if there's a current running through the fuse.

Get More Info ›

What does a fuse look like on a circuit diagram? ›

Flexi Says: A fuse in a circuit diagram is typically represented by a rectangle or a squiggly line. The rectangle is more common in American diagrams, while the squiggly line is more common in European diagrams.

View Details ›

How to find a short in a car blown fuse? ›

To check fuses and see if there are any easy-to-reach short circuits: Remove a fuse at random and connect your test light to the terminals for the fuse socket (the place where the fuse connects to the electrical system). The test light will light up if an electrical current is detected.

Explore More ›

What fuse controls the dashboard? ›

Which Fuse Controls the Dashboard Gauge? The instrument cluster fuse manages the dashboard gauge of a vehicle. It uses electricity from the car battery to power various electronic components of the dashboard such as the different warning lights, gauges, and alarm systems.

Read On ›

What fuses turn on with ignition? ›

A switched fuse is one that only has power when the ignition is turned on, while a constant fuse always has power.

Tell Me More ›

What fuse would stop a car from starting? ›

One possible reason why your car won't start no crank is that the fuse for the ignition switch is blown. You can check the fuse by locating it in the fuse box and inspecting it for any damage or breakage. If the fuse is faulty, you will need to replace it with a new one.